SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.

Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|

These are new O-rings for the water pipes that run between the water pump housing and the cylinder heads on International V8 and 4-cylinder engines.
On 392IC motors (Improved Cooling) motors, the water pipes go to the front of the block, but the O-ring is the same.
There are 4 provided per s
|
Our Price: $8.87 each
|

For years we drove our Scouts without cup holders. One day we got tired of spilling coffee all over the seat and designed the floor mount cup holder.
The cup holder is made of heavy 18 gauge stainless steel (not at all flimsy), is laser cut, and is perfectly suited to mount in any Scout II without
|
Our Price: $49.95
|

There are 14 screws and special washers here, which are enough screws to affix one Scout II door panel to the door.
|
Our Price: $22.34 each
|

We had a really hard time finding these, so we decided to make them ourselves. Replace your old filter with this and stop your oil filter adapter from leaking. If you are updating your older filter with a newer spin-on adapter, you will need one of these.
|
Our Price: $32.53 each
|

Front Suspension Axle Stop Bumper Rubber
|
Our Price: $20.92 each
|

We've put this kit together for your IH Scout II to seal up the rear of your rig!
Includes :
-- Lower tailgate seal (the weather-strip under the tailgate)
-- Side tailgate seals (two vertical seals on the two sides of your tailgate, if you take your top off)
-- Upper liftgate seal (the seal at t
|
Our Price: $102.79 each
|

|
Our Price: $14.17 each
|

MT130 Parts manual, Scout II, 1971-80. Traveler, Terra. Originally printed material from International Harvester detailing the assembly order and part numbers for each device and system of the Scout vehicle.
|
Our Price: $112.91 each
|

This easy install wiper blade works with the stock Scout II wiper arms. Some Scout II's have wiper arms that require a small bolt to hold the blade on. Look for two small holes at the end of your wiper arm.
Some Scout II's have a post on the wiper arm.
|
Our Price: $24.95 each
|

The Super Scout or SS II used this front grill. These high-quality replacements can be used on 1976-1979 Scout II and are a great upgrade. You will need to modify your stock front sheet metal to accept this piece. Made in the USA
Dress up your Scout with this attractive black grill insert. Fits all
|
Our Price: $282.28 EACH
|

Brand new reproduction Scout II liftgate T-handle
Comes with mounting pad, screws and keys
|
Our Price: $299.95 Each
|

Includes, housing, lens and LED lights and pigtail. This is an almost perfect fit. The screw holes are a match but the unseen recess may need to be trimmed 1/16"th with just a little bit of filing.
|
Our Price: $49.65 each
|

These are the original factory spring bushings to fit all Scout 80 & Scout 800 springs. 7/8" diameter. These will give your truck the ride it had when it was new.
You may need a press to install these. Check out SP12758 for aftermarket urethane spring bushings that are easier to install.
|
Our Price: $18.82 each
|

Divorced choke control and used in accelerator linkage of Scout II, Metros, Travelalls, and Pickups. Parts books MT117, 124, 130, 131
|
Our Price: $6.92 each
|

Now you can rebuild your own power steering gear with our rebuild kit! This comes with all of the seals, gaskets, and bearings required to rebuild your Saginaw power steering box at home.
Recirculating balls are not included, nor are they typically required.
We also can rebuild your old ste
|
Our Price: $149.25 each
|

Electric wiper motors are reliable, easy to install, and an excellent upgrade for any Scout 80 & 800. Kit includes hardware, harness, wiper arm, and blade for one side. Stainless housing.
Note : These fit really well for 1961-1965. Some modification to your dash will be required for the 66-71 Scou
|
Our Price: $158.10 IN STOCK NOW!
|

This is a complete set of 9 new LED lights to replace your old incandescent bulbs. You know, the ones that seem to only burn out when you are giving a ride to your mother in-law that does not quite like you...yet.
SPEEDO:
2 Illumination LEDs
2 Turn Signal
1 4x4 Engage
1 E-brake
1 Brights
ALT/FUEL:
|
Our Price: $33.26 set of 9 bulbs and inserts/sockets
|

A canister type Engine oil filter with a gasket for a Scout 80/800.
Scout engine oil filter
|
Our Price: $37.88 each
|

These are aftermarket rubber gaskets, sold in pairs to do 2 doors (2 small pieces, 2 large pieces). For 4 door trucks and Travelalls be sure to order two kits!
Scout 66-71 Scout 800 and 61-68 IH Pickup
(handle not included)
|
Our Price: $19.99 each
|

If you have a 4 cylinder Scout 80, 800 there's a good chance you may need one of these. They tend to have gotten rusty and weak in the last 40 years.
|
Our Price: $23.87 each
|

For #8 Screw.
|
Our Price: $1.44 each
|

This seal kit fits Dana 27, Dana 30, and Dana 44 closed-knuckle front axles used in Scout 80, 800, pickups, and Travelalls. This kit seals around the large ball behind the knuckle.
This kit comes with the rubber seal, felt seal, metal seal retainers, and retainer bolts. One kit is enough to servi
|
Our Price: $83.17 each
|

If you are trying to make your old Window regulator work and or if you have another from another year of scout and you want to reattatch your fan gear, this is the exact rivit that you need to rehab your Window regulator. Used on all IH's from 1940 to 1971
|
Our Price: $15.69 each
|

All Scout II vehicles use this tail lamp housing gasket between the metal or plastic (depending on year) housing and the body. Without this gasket the tail lamp housing fills with water, the contacts corrode, and eventually the bulb fails.
1971-78 Scout II, 1969-75 IH Pickup
soft cork material
repl
|
Our Price: $14.75 each
|

1 pair of brand new hood bumpers for Scout 80/800
5/16-24 thread, 1.25" stud length
Includes jam nuts
|
Our Price: $14.95 Pair
|

If you have aftermarket wheels they may be thicker than the originals. These studs are 1-15/16 inch long compared to stock 1-5/8 inch long. If you need longer studs these may work for you.
#wheelbolt
|
Our Price: $7.89 each
|

Plastic heater valve replacement for all Scout 80 & 800, Scout II, Travelalls, and pickups with inline heater valve. While this is not a cadmium-plated steel unit like original, this plastic valve actually moves more easily, and will never rust away like the originals did. Install this and lubrica
|
Our Price: $56.73 each
|
|