SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
This is the front parking brake cable for all Scout II except those with diesel engines. If you have a diesel engine, see SP13718.
Most cables have either fused with rust from road salt, or have been frayed from abuse. Not only is it dangerous to not have a functional emergency brake, but it is il
|
Our Price: $172.89 each
|
Every scout 80/800 needs 4 of these. The hole size is 1 3/8", which may not be stock depending on your year.
Front and rear shackle mount Scout 80/800
|
Our Price: $64.42
|
Gasket that goes on the top of your Scout 80, Scout 800 gas tank. Need one per gas tank. This gasket is only used on original metal fuel tanks.
|
Our Price: $11.42 each
|
We've put this kit together for your IH Scout II to seal up the rear of your rig!
Includes :
-- Lower tailgate seal (the weather-strip under the tailgate)
-- Side tailgate seals (two vertical seals on the two sides of your tailgate, if you take your top off)
-- Upper liftgate seal (the seal at t
|
Our Price: $102.79 each
|
New replacement Scout II side marker kit in chrome
Fits: 1971-80 Scout II, 1976-80 Traveler/Terra & 1969-75 Pickup/Travelall
Includes:
4 chrome plated metal bezels
2 amber lights and 2 red lights
Pre-installed foam gaskets
8 screws and 4 retainer clips
We also have these available with a satin bl
|
Our Price: $149.95 Full Set
|
Kit includes one pair of motor mounts and hardware to mount a 4 cylinder motor in a Scout 1961-71.
|
Our Price: $178.87 each
|
White plastic door seal retainers. Used on all Scouts of all years.
|
Our Price: $0.90 each
|
This valve seat retains the valve spring. these are used on all IH 4 and 8 cylinder engines.
|
Our Price: $11.76 each
|
395944C1, This little clip was used on just about all IH rigs. This little clip holds on many of your door seals. The earlier ones were metal and have now rusted away.
|
Our Price: $0.90 each
|
Brand new interior door handle for Scout 80 and Scout 800.
Exact reproduction of the original handle. Can also be drilled and used as a replacement for bolt on style handles used on some Scouts.
|
Our Price: $13.84 EACH
|
Sold as a set of four. These are new replacement shackle Plates for Scout 80, 800. They do not come with bolts.
They are within 1/2" of stock height.3" center to center on the holes.
|
Our Price: $50.41 Set of 4
|
These are new U-joints to fit the front axle shafts on Dana-44 open-knuckle front axles used in Scout II, Travelalls, and pickups, including 1000, 1100, 1200, 1010, 1110, 1210, 100, 150, and 200 4x4 chassis.
|
Our Price: $46.68 Each
|
All connectors are included. This is a new replacement wiring harness for the engine compartment of Scout II vehicles.
New wires will make your Scout II start and run reliably once more. Made from original IH blueprint specifications. Specific for Scout II 4, and 8 cylinders.
If you have a 6-cy
|
Our Price: $518.10 - $518.10 each
|
This seat is a good fit for Scout II. These have to be special-ordered, so there may be an extra week of ship time.
Covered with high quality long lasting vinyl. Reclinable
This seat requires custom fabrication to mount to the stock pedestals.
|
Our Price: $520.60 each
|
These are aftermarket rubber gaskets, sold in pairs to do 2 doors (2 small pieces, 2 large pieces). For 4 door trucks and Travelalls be sure to order two kits!
Scout 66-71 Scout 800 and 61-68 IH Pickup
(handle not included)
|
Our Price: $19.99 each
|
|
Our Price: $29.95 Each
|
Each kit of polyurethane bushings will service one axle and tighten up your ride quality while eliminating squeaks.
The overall length of these bushings is 2.25 inches, 1.25 outside diameter. this works with stock shackles or our aftermarket shackles.
|
Our Price: $97.98 each
|
CURRENTLY BACKORDERED
215114R1***You are ordering the pin pictured, if you want the slave cylinder order sp11773***
Fits Scout 80 and 800 with hydraulic clutches, extra heavy duty service. Clutch Slave Cylinder actuator pin. This part was made 3/16 longer than original equipment. Specifically manuf
|
Our Price: $53.13 BACKORDERED
|
If you have an A, B, or C-series Travelall or pickup, and cannot find blades for it, or yours have gotten so bad over the years that you cannot use it anymore, we have the correct replacement blades for you. These are new rubber blades and the bracket or holder that attaches it to the arm. The bla
|
Our Price: $52.81 each
|
1 pair of brand new hood bumpers for Scout 80/800
5/16-24 thread, 1.25" stud length
Includes jam nuts
|
Our Price: $14.95 Pair
|
New Scout II Glove Box. Cardboard just like OEM, Looks great in your truck!
|
Our Price: $64.75 each
|
Brand-New IH Scout II Accelerator / Throttle Cable Part. This cable is 28-5/8" end to end.
This is the REAL DEAL IH Part. part 440983C1
73-75 6-232/258 engines
To fit the 1973-1978 Scout II with 304 / 345 V8.
This cable has a socket fitting on the carburetor end, and a ball on the gas pedal en
|
Our Price: $99.50 each
|
Valve cover gasket for IH engines: 152, 196, 266, 304, 345, 392
All valve cover gaskets are made of cork. Rubber is no longer available.
Not sold in pairs. For V8 application, order 2
|
Our Price: $27.95 Each
|
This is a new electrolock ignition switch used on Scout 80 and 800, as well as R, S, A, B, C, D-series trucks. This might also fit L and M-series (Metro) trucks and also fit many larger trucks and busses including Schoolmaster, Loadstar, Paystar, et cetera.
This switch comes with a new chrome lo
|
Our Price: $54.95 each
|
Twin stick transfer case shifting instructions decal for Scout 80 and 800 vehicles.
decal, scout, binder, transfer case, decal, international harvester
2752604R2
|
Our Price: $32.20 each
|
Scout 80/800 clutch slave cylinder stainless steel hose. This replaces the rubber hose connection to the slave cylinder, and is sold complete with all necessary hydraulic fittings.
|
Our Price: $76.21 each
|
No need to cut any wires; connector adapter included in the kit. This courtesty door switch works great on Scout II's, Travelall's and pickups.
This kit includes: adapter pig tail, self-tapping screw, and water proof switch.
****not going to work well for a 60s scout****
|
Our Price: $22.90 each
| |
