SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
2753948r1. Fits: 1966-1971 Scout 800, 800A, 800B
Die cast design like the original
Chrome plates and textured on the inside
Includes retaining clips
|
Our Price: $48.9
|
Windshield wiper blade for your IH Scout 80 or Scout 800.
(Includes installation instructions)
NO RETURNS
|
Our Price: $19.48 each
|
New Old stock comes with "IH" keys. The "IH" keys were made in the 1960's and have IH embossed into both keys.
This is a new electrolock ignition switch used on Scout 80 and 800, as well as R, S, A, B, C, D-series trucks. This might also fit L and M-series (Metro) trucks and also fit many large
|
Our Price: $54.95 each
|
Passenger side fuel tank filler neck (hose) for Scout 80 and Scout 800 fuels tanks on the passenger side of the vehicle. This assembly includes the air vent hose, and connects the fuel tank to the filler flange on the rear fender.
See also the Drivers side
|
Our Price: $133.45 each
|
This is a brand-new, side marker light assembly to fit all Scout II trucks, as well as 1971 to 1975 D-series pickups and Travelalls. This comes complete with new chromed bezel, lens, gasket, mounting gasket, and screws. Nothing makes as big a difference as new lights!
Available in red and amber,
|
Our Price: $69.93 - $69.93
|
The later Scout II trucks used a plastic tail light housing. This is the replacement lamp socket for the upper socket which holds the tail and brake lamp (dual contact). Buy this socket if your old one is rusted and will not accept a tail lamp.
Made in the USA
 |
Our Price: $17.67 each
|
Foam gasket between the steel tail light housing and the body on early scout II's and D line pickups
|
Our Price: $9.08 each
|
Priced each. These are very nice reproductions of the forward body mounts (located near the front of of the front floorpan) used on Scout II. Goes under your feet as you drive down the road. The originals have typically rusted away or fatigued to the point they break or bend. Now you can get your
|
Our Price: $92.67 each
|
The Super Scout or SS II used this front grill. These high-quality replacements can be used on 1976-1979 Scout II and are a great upgrade. You will need to modify your stock front sheet metal to accept this piece. Made in the USA
481685C1 SSII or Scout II grille
|
Our Price: $282.28 EACH
|
A canister type Engine oil filter with a gasket for a Scout 80/800.
Scout engine oil filter
|
Our Price: $37.88 each
|
NEW "Scout" script emblem. Give that restoration project the finishing touch with emblems like these.
860265R1
|
Our Price: $82.42 each
|
Automatic Shift Dial Plate
Park, Reverse, Neutral, Drive, Low Plate
Automatic gear indicator comes as pair - blank and lettered plates
Made in the USA
![](\"/images/usaflag-backed.gif\")
|
Our Price: $58.34 each
|
This clip replaces the original clip and spacer. It is made of a rigid plastic and will do the job as good as the original.
|
Our Price: $25.2 each
|
_241785.jpg)
Replacement Wiper Blades for our Scout II Wiper Arm and Blade Replacement Kit. When you need replacement blades we have them.
|
Our Price: $12.79 each
|
Super good, super strong, super resistant to gas, oil and diesel. Use gloves when applying. So good that it is hard to get off your hands.
This item has to ship ground because it's ORM-D, which makes the freight high to remote locations.
|
Our Price: $15.61 each
|
This is a new knob for the hood release cable on the dashboard. This is the later version which was made of plastic, but can be used to replace the earlier metal knob too. Often these are completely missing, either because they split, or because the cable got stuck and the knob came off. If your
|
Our Price: $29.95 each
|
Dash board light bulb
Lights up heater, head light and wiper indicators
|
Our Price: $2.13 each
|
This is a factory-authorized reprint of the CTS-2304 service manual for all Scout II trucks built between 1972 and 1975 only. This is not anything like a Chilton's or a Haynes manual, but is a 600 page factory technical service manual with complete instructions and illustrations to guide you in you
|
Our Price: $129.01 each
|
Brand-New IH Scout II Accelerator / Throttle Cable Part. This cable is 28-5/8" end to end.
This is the REAL DEAL IH Part. part 440983C1
73-75 6-232/258 engines
To fit the 1973-1978 Scout II with 304 / 345 V8.
This cable has a socket fitting on the carburetor end, and a ball on the gas pedal en
|
Our Price: $104.5 each
|
Overall width 2" inches. These spring bushing kits service one axle on your 800A or 800B. 800A and 800B spring bushings are 1.2" in diameter.
These bushings replace the ones located in the spring eyes as well as those located in the spring mounts welded to the frame.
|
Our Price: $70.85 each
|
Kit designed to allow a pre-1985 Chevy 350 motor to be mounted in a Scout II. These Universal engine mounts are designed for use on all types of 4WD and 2WD vehicles that have frame rail widths
up to 32". The bracket can be either welded or bolted into position. Kit includes hardware, mounts and bra
|
Our Price: $249.4 each
|
Shifter boot for Scout II Automatic transmission. This boot will also work for Scout 800 A & B Single shifter transfer case.
431600c1
|
Our Price: $64.16 ea
|
Such a cool and unique cap. The waxed cloth has a hardened "old leather" look and feel to it.
Brown washed wax cloth and nylon mesh back cap.
Velcro closure on back.
International Harvester hat
|
Our Price: $19.95 each
|
1961-1967 Scout 80 and 800 could have Detroit or Cleveland type universal joints (as pictured). These U-joints have an internal lock ring instead of the external ring outside the cap. The cap diameter is about an inch and they are used on the Dana 27.
|
Our Price: $54.06 each
|
We now have brand new shifter knobs to fit Scout 80, Scout 800, and pickups and Travelalls. This was used on 3 and some 4-speed transmissions used in C, K, KB, M, L, R, S, A, B, and C-series trucks.
Made of phenolic rubber like the original, This has a 3/8" SAE (fine) thread. If this is not c
|
Our Price: $31.53 each
|
After market non-oem Stainless Steel head light bezel rings. Excellent restoration piece. 9.25" OD 7.25" ID.
APPLICATION DETAILS:
1961-71 Scout-very close to original look
1941-49 K/KB- Fit all models with close to original look
|
Our Price: $39.95 EACH
|
This body mount kit is an extremely close reproduction of the original bushings used by International Harvester in the 1960s.
Every bump and curve has been reproduced in the smallest detail. These are not plastic washers repackaged to fool you into thinking that these are a body mount kit.
This
|
Our Price: $149.95
| |
