SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
This is a brand-new, side marker light assembly to fit all Scout II trucks, as well as 1971 to 1975 D-series pickups and Travelalls. This comes complete with new chromed bezel, lens, gasket, mounting gasket, and screws. Nothing makes as big a difference as new lights!
Available in red and amber,
|
Our Price: $69.93 - $69.93
|
Overall width 2" inches. These spring bushing kits service one axle on your 800A or 800B. 800A and 800B spring bushings are 1.2" in diameter.
These bushings replace the ones located in the spring eyes as well as those located in the spring mounts welded to the frame.
|
Our Price: $70.85 each
|
Scout 80 new replacement exterior door handles. These handles come with keys. These are an excellent non-oem replacement to add to any quality restoration.
These handles may also be used on Metros
|
Our Price: $68.82
|
Front Suspension Axle Stop Bumper Rubber
|
Our Price: $20.92 each
|
The later Scout II trucks with the plastic tail light housings use this replaceable lamp socket. This is the lower of the two sockets, accepts a single contact reverse bulb, and is a direct replacement for you worn or rusted socket.
|
Our Price: $17.67 each
|
If you get your Scout out on some gravel and apply brake pressure you can determine if either the front or rear brakes are locking up too early. This adjustable proportioning valve allows you to fine tune the front to rear braking pressure.
|
Our Price: $67.72 each
|
If you have aftermarket wheels they may be thicker than the originals. These studs are 1-15/16 inch long compared to stock 1-5/8 inch long. If you need longer studs these may work for you.
#wheelbolt
|
Our Price: $7.89 each
|
FITS ORIGINAL SCOUT II GAS CAP
This fuel filler tube is a reproduction of the original. It is new, made of steel, and fits both Scout II gas and diesel, 19 and 33 gallon tank.
Will fit standard (SP12935) gas cap as well as our aftermarket locking gas caps (SP13749)
|
Our Price: $296.24 each
|
Fits: 1971-80 Scout II, 1976-80 Traveler/Terra & 1969-75 Pickup/Travelall
Includes 4 metal bezels, 2 red lens/lights, 2 amber lens/lights, pre-installed foam gaskets and mounting hardware.
419799C1, 404498C21, 418977C91, 404155C91 amber, 404156C91 red
|
Our Price: $149.95
|
This LED bulb replaces the side marker lamp in either the front or rear side marker of the Scout II, also works in the dash lamps.
|
Our Price: $11.88 each
|
MT130 Parts manual, Scout II, 1971-80. Traveler, Terra. Originally printed material from International Harvester detailing the assembly order and part numbers for each device and system of the Scout vehicle.
|
Our Price: $112.91 each
|
This is an NOS bolt for the connecting rods.
These are the bolts that attach your piston rods to the crankshaft.
|
Our Price: $29.2 each
|
395944C1, This little clip was used on just about all IH rigs. This little clip holds on many of your door seals. The earlier ones were metal and have now rusted away.
|
Our Price: $0.9 each
|
This body mount kit is an extremely close reproduction of the original bushings used by International Harvester in the 1960s.
Every bump and curve has been reproduced in the smallest detail. These are not plastic washers repackaged to fool you into thinking that these are a body mount kit.
This
|
Our Price: $142.06 each
|
Our heavy duty antennas are low cost but high quality. These antennae are just like what comes on a brand new International overland truck. Here are some basic features:
Stainless Steel
Spring Loaded
31" Mast
60" Cable
Universal Fit
|
Our Price: $57.29 each
|
Gasket that goes on the top of your Scout 80, Scout 800 gas tank. Need one per gas tank. This gasket is only used on original metal fuel tanks.
|
Our Price: $11.42 each
|
This seal is made for the lower rear cab top. The original was poorly designed because it allowed the metal of the top to rub against the metal of the bulkhead in direct contact, destroying your paint. This is new and improved!
|
Our Price: $59.95 each
|
This is a plastic Sheet metal Screw nut used in scout II doors and many other IH Trucks and Travelalls.
fits a size 8 Screw and a 9MM (3/8)Square hole
|
Our Price: $0.53 each
|
This kit works on metal tail lights only. Kit includes all of the necessary components to get the rear lights (both sides) working on a Scout II (1971-1975). Most of the tail gaskets have failed on these trucks. The bulb contacts rust from moisture and ruin the rear tail light sockets. Kit includes:
|
Our Price: $96.28 each
|
Scout 80/800 clutch slave cylinder stainless steel hose. This replaces the rubber hose connection to the slave cylinder, and is sold complete with all necessary hydraulic fittings.
|
Our Price: $75.21 each
|
All of the gas motors in all models of Scout and Scout II use these Champion brand spark plugs. We typically gap spark plugs to .035 when installing, which is very close to the Champion factory gap.
|
Our Price: $5.41 each
|
Emblem is for fender badges on all Scout IIs as well as the 1961 to 75 trucks & Travelalls. Dress up that truck with little detail items like this badge.
These are made of base metal and chrome-plated and enamel-painted. These are held on with metal posts on the back side.
|
Our Price: $78.95 each
|
Pin; straight interior handle for window and door.
Holds interior handles on the inside of door.
|
Our Price: $10.17 per pin
|
Includes wiring for indicator lights. Includes detailed directions. This harness is used to make wiring EASY for installing our Scout II gauge kit. product #sp13689. This harness is completely pre-wired and every wire is labeled. It is all ready to plug right into the original factory plastic gauge
|
Our Price: $226.1 each
|
Windshield wiper blade for your IH Scout 80 or Scout 800.
(Includes installation instructions)
NO RETURNS
|
Our Price: $19.48 each
|
Shifter boot for Scout II Automatic transmission. This boot will also work for Scout 800 A & B Single shifter transfer case.
431600c1
|
Our Price: $64.16 ea
|
***You are ordering the pin pictured, if you want the slave cylinder order sp11773***
Fits Scout 80 and 800 with hydraulic clutches, extra heavy duty service. Clutch Slave Cylinder actuator pin. This part was made 3/16 longer than original equipment. Specifically manufactured for the customers with
|
Our Price: $53.13 each
| |
