SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
Our challenger type steering wheel has been tested for fit and finish in your Scout II. A great replacement steering wheel for your 71-80 Scout.
Black foam cushion grip with matte black 3-spokes. 13-3/4" diameter, 2-1/4" dish.
Note : if you don't already have an after-market steering wheel, you w
|
Our Price: $179.42 each
|
We now have brand new shifter knobs to fit Scout 80, Scout 800, and pickups and Travelalls. This was used on 3 and some 4-speed transmissions used in C, K, KB, M, L, R, S, A, B, and C-series trucks.
Made of phenolic rubber like the original, This has a 3/8" SAE (fine) thread. If this is not c
|
Our Price: $31.53 each
|
This part will connect a custom steering wheel to your old Scout. You will retain your horn as well as your turn signal cancel. IT WORKS! You cant get this anywhere else!
This is for a 1961-1971 Scout 80 or 800.
If you need this part for a Scout II, use SP16464
|
Our Price: $72.09 each
|
This is a Scout II tail gate emblem that says "International". 8" X 1"
These have gotten very scarce for a long time, they are back in a brand new reproduction! 6 inches between pegs.
Tailgate
2754244R1
International badge
|
Our Price: $82.95 Each
|
Fuel sender gasket o-ring for original steel fuel tanks. If you have an aftermarket polyethylene tank, you need SP19180.
|
Our Price: $7.08 each
|
"O" ring, for water pipes on all IH engines .
|
Our Price: $2.97 each
|
This is a new knob for the hood release cable on the dashboard. This is the later version which was made of plastic, but can be used to replace the earlier metal knob too. Often these are completely missing, either because they split, or because the cable got stuck and the knob came off. If your
|
Our Price: $29.95 each
|
***seat belts currently made to order, lead time involved***
These 3 point seat belts have an adjustable buckle lead. They are much safer than the original 2 point seat belts.
They are NOT the type that the factory installed.
To use these seat belts you will have to fabricate a 3rd anchor point.
|
Our Price: $141.27 each
|
We need to know if you have a 60s or 70s scout. Includes 2 bolts,4 washers,2 nuts. Each scout requires 4 bolts for the front seat and 3 bolts for the back seat.
|
Our Price: $5.83 each
|
These are the plastic pivot bushings or bearings used on Scout 80 and 800, Scout II, and D-series pickups and Travelalls without hydraulic clutches. These fit inside the end of the bellcrank (also known as the clutch relay lever or cross shaft) around the each of the round balls on the frame and th
|
Our Price: $48.67 each
|
Brand new windshield seal for all years of Scout II, Scout II Terra, and Scout II Traveller. This seal is a direct replacement for the worn or leaking seal you may currently have; replacing a bad seal will keep the windshield frame from rusting.
This comes with a black locking strip but accepts a c
|
Our Price: $150.40 each
|
If you have a fancy fabric or vinyl interior door panel, These clips are probably what holds it on to the door. These were used on all IH scouts & trucks built in the 1960's. They almost always break when you remove the old corroded ones.
|
Our Price: $2.17 each
|
This is the gasket between the side marker light housing and the body on 1971 to 1980 Scout II
|
Our Price: $4.53 each
|
395944C1, This little clip was used on just about all IH rigs. This little clip holds on many of your door seals. The earlier ones were metal and have now rusted away.
|
Our Price: $0.90 each
|
Brand new wiper switch for Scout II. Two speed switch, push to wash, internal circuit breaker.
|
Our Price: $89.98 each
|
Fuel Gas tank Selector switch for Scout 80-800, manual type.
Includes three fuel line connector fittings.
Switches tanks with a 90-degree swing instead of 180-degrees like the original.
|
Our Price: $102.39
|
If your gauges are reading incorrectly or not at all, you may need this brand new high capacity solid state regulator kit. It replaces the old mechanical one behind your Oil/Temp guage. NO MOVING PARTS!! This regulator has a capacity far beyond the original and will never burn out under these loads.
|
Our Price: $59.03 each
|
Priced each. These are very nice reproductions of the forward body mounts (located near the front of of the front floorpan) used on Scout II. Goes under your feet as you drive down the road. The originals have typically rusted away or fatigued to the point they break or bend. Now you can get your
|
Our Price: $92.67 each
|
These are replacement wheel studs for the front wheels only on Scout IIs with disc brakes. Please specify whether you want right or left-hand threads. Sold each.
|
Our Price: $5.74 each
|
Easy to install - NO soldering MUST BE GROUNDED!
If your gauges are reading incorrectly or not at all, you may need this brand new high capacity solid state regulator kit. It replaces the old mechanical one behind your Oil/Temp gauge. NO MOVING PARTS! This regulator has a capacity far beyond the
|
Our Price: $69.17 each
|
Original type temperature sending units screw into the intake manifold near the water jacket, and accept the stock female spade connector. Pipe thread measures 1/2"
|
Our Price: $52.63 each
|
Valve cover gasket for IH engines: 152, 196, 266, 304, 345, 392
All valve cover gaskets are made of cork. Rubber is no longer available.
Not sold in pairs. For V8 application, order 2
|
Our Price: $27.95 Each
|
This is an NOS bolt for the connecting rods.
These are the bolts that attach your piston rods to the crankshaft.
|
Our Price: $29.20 each
|
We only have three. New Old Stock.
This is the best side view mirror to use for your Scout II. New old stock mirror made by IH in the 1970's. This is the replacement mirror that your IH dealer would have sold you in 1970's.
- Mounting holes may need to be re-drilled -
|
Our Price: $742.99 EACH
|
New Scout II ignition lock cylinder with keys
Comes with two unbranded keys that do not have the international logo
|
Our Price: $39.95 Each
|
162815R1. This brand new steering column to firewall seal has been made to the exact specifications used for the original seals.
|
Our Price: $35.40 Each
|
These are the original factory spring bushings to fit all Scout 80 & Scout 800 springs. 7/8" diameter. These will give your truck the ride it had when it was new.
You may need a press to install these. Check out SP12758 for aftermarket urethane spring bushings that are easier to install.
|
Our Price: $18.82 each
| |
