SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
Emblems for 71-80 Scout II.
All emblems are sold separately, as well.
This kit includes:
2x New Scout II IH Fender Emblem
2x New Scout II Rear Side "II" Emblem
2x New Scout II Rear Side Emblem
|
Our Price: $389.64
|
New bolt set for your Scout II travel top. The travel top is the standard top used on 100" wheel base Scout II vehicles. These bolts hold the top down to the body.
|
Our Price: $24.16 each
|
This body mount kit is an extremely close reproduction of the original bushings used by International Harvester in the 1960s.
Every bump and curve has been reproduced in the smallest detail. These are not plastic washers repackaged to fool you into thinking that these are a body mount kit.
This
|
Our Price: $149.95
|
Easy to install - NO soldering MUST BE GROUNDED!
If your gauges are reading incorrectly or not at all, you may need this brand new high capacity solid state regulator kit. It replaces the old mechanical one behind your Oil/Temp gauge. NO MOVING PARTS! This regulator has a capacity far beyond the
|
Our Price: $60.17 each
|
This is the gasket between the side marker light housing and the body on 1971 to 1980 Scout II
|
Our Price: $4.53 each
|
This is a replacement screw for your door striker plate. That is the plate that is screwed to the body. It receives the door when you close it. Many people have problems with their doors not closing right and they just keep slamming them harder and harder.
These replacement screws are longer, which
|
Our Price: $3.89 each
|
Price is for one front and one rear. If you have tinkered with the roll up windows of your scout 80 & 800 and you just can't make them roll up and down smoothly, there's a good chance you need new front
|
Our Price: $74.85 each
|
After market non-oem Stainless Steel head light bezel rings. Excellent restoration piece. 9.25" OD 7.25" ID.
APPLICATION DETAILS:
1961-71 Scout-very close to original look
1941-49 K/KB- Fit all models with close to original look
|
Our Price: $39.95 EACH
|
_241785.jpg)
Replacement Wiper Blades for our Scout II Wiper Arm and Blade Replacement Kit. When you need replacement blades we have them.
|
Our Price: $12.79 each
|
Includes, housing, lens and LED lights and pigtail. This is an almost perfect fit. The screw holes are a match but the unseen recess may need to be trimmed 1/16"th with just a little bit of filing.
|
Our Price: $49.65 each
|
If your gauges are reading incorrectly or not at all, you may need this brand new high capacity solid state regulator kit. It replaces the old mechanical one behind your Oil/Temp guage. NO MOVING PARTS!! This regulator has a capacity far beyond the original and will never burn out under these loads.
|
Our Price: $59.03 each
|
Gasket and seal kit for the Dana 20 transfer case used in most Scout II's. Easily identifiable, the Dana 20 had high and low speeds.
|
Our Price: $74.72 each
|
Newly manufactured "All Wheel Drive" emblem for Scout 80/800.
|
Our Price: $75.62 each
|
New escutcheon for your door handle spacer. It\'s new and in stock! Just as easy to install as the original. You\'ll look forward to taking apart your doors. :)
|
Our Price: $14.95 CURRENTLY BACKORDERED
|
All connectors are included. This is a new replacement wiring harness for the engine compartment of Scout II vehicles.
New wires will make your Scout II start and run reliably once more. Made from original IH blueprint specifications. Specific for Scout II 4, and 8 cylinders.
If you have a 6-cy
|
Our Price: $508.10 - $508.10 each
|
Warn hub gaskets 2 are needed per side. there was a smaller gasket but it is very rare.
|
Our Price: $10.95 each
|
This is the actuator for the turn signal switch on Scout II and D-series pickups and Travelalls, Metros, and some later Scout 800 vehicles. This was used in Saginaw steering columns. This is the part that bumps the swinging cam on the turn signal switch, and that causes the signal to shut off afte
|
Our Price: $27.08 each
|
We now have brand new shifter knobs to fit Scout 80, Scout 800, and pickups and Travelalls. This was used on 3 and some 4-speed transmissions used in C, K, KB, M, L, R, S, A, B, and C-series trucks.
Made of phenolic rubber like the original, This has a 3/8" SAE (fine) thread. If this is not c
|
Our Price: $31.53 each
|
This is a factory-authorized reprint of the CTS-2302 service manual for all Scout 80 and 800 trucks. This is not anything like a Chilton's or a Haynes manual, but is a 400 page factory technical service manual with complete instructions and illustrations to guide you in your work. This does not h
|
Our Price: $84.89 - $124.81 each
|
These are new U-joints to fit the front axle shafts on Dana-44 open-knuckle front axles used in Scout II, Travelalls, and pickups, including 1000, 1100, 1200, 1010, 1110, 1210, 100, 150, and 200 4x4 chassis.
|
Our Price: $46.68 each
|
These are brand new. They are EXACTLY OEM and will fit Scout 80, Scout 800, and Sport Scout. Please note that due to the use of natural rubber in these cylinders, it is necessary to use a special hydraulic fluid. We recommend using the Lucas fluid (SP10162), which has lubricants added to prolong
|
Our Price: $166.3 each
|
Brand new interior door handle for Scout 80 and Scout 800.
Exact reproduction of the original handle. Can also be drilled and used as a replacement for bolt on style handles used on some Scouts.
|
Our Price: $12.84
|
These are the original factory spring bushings to fit all Scout 80 & Scout 800 springs. 7/8" diameter. These will give your truck the ride it had when it was new.
You may need a press to install these. Check out SP12758 for aftermarket urethane spring bushings that are easier to install.
|
Our Price: $18.82 each
|
Bet you didn't know you can replace that worn out ring gear on your flywheel! If your starter 'sings' to you every time you go to start your truck, you need to replace the ring gear. This is a much cheaper alternative to replacing the flywheel.
This is used on all flywheels used on the IH eng
|
Our Price: $106.59 each
|
Installation kit necessary for after market steering wheel use on a Scout II. Kit works with any of the three steering wheels that we carry.
Kit includes the adapter to the new steering wheel, the horn contacts, and plate, the mounting hardware, and detailed installation instructions.
|
Our Price: $102.87 each
|
This is a brand-new sill scuff plate for the side door thresholds on your Scout II. This is the metal plate that holds the weatherstrip down on the flange and protects it against tearing due to scuffing when you climb in and out of the vehicle.
These are brand new extruded aluminum with standard
|
Our Price: $78.74 each
|
We have brand new transfer case shifter knobs for your Scout 80 or 800. These are identical to the original units. It is amazing how much difference little items like these make in your truck restoration. Sold in pairs.
|
Our Price: $19.73 - $126.32 pair
| |
