SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
Valve cover gasket for IH engines: 152, 196, 266, 304, 345, 392
All valve cover gaskets are made of cork. Rubber is no longer available.
Not sold in pairs. For V8 application, order 2
|
Our Price: $27.95 Each
|
#25 in the above diagram is the part you are looking at
#24 is SP18769
#21 is SP10562
Door to body seal kit.
Applies to the body and the top of the Scout with glue (not included, ask). The door closes against the seal.
Includes upper and lower seals for both left and right doors.
Fits 1963-71 I
|
Our Price: $141.32 each
|
No need to cut any wires; connector adapter included in the kit. This courtesty door switch works great on Scout II's, Travelall's and pickups.
This kit includes: adapter pig tail, self-tapping screw, and water proof switch.
****not going to work well for a 60s scout****
|
Our Price: $22.90 each
|
This is the actuator for the turn signal switch on Scout II and D-series pickups and Travelalls, Metros, and some later Scout 800 vehicles. This was used in Saginaw steering columns. This is the part that bumps the swinging cam on the turn signal switch, and that causes the signal to shut off afte
|
Our Price: $27.08 each
|
This is a new Gasket for your fuel sender to gas tank.
|
Our Price: $8.20 each
|
395944C1, This little clip was used on just about all IH rigs. This little clip holds on many of your door seals. The earlier ones were metal and have now rusted away.
|
Our Price: $0.90 each
|
Tail light wiring harness (pigtail) for rear tail/brake bulb sockets.
|
Our Price: $34.95 each
|
Brand New Scout 80/800 windshield seals! Soft and pliable to get you through the next 40 years.
|
Our Price: $146.67 each
|
Kit includes 2 high quality heavy duty shackles and hardware necessary to mount them on either the front or rear springs of any Scout 80 or Scout 800. Purchase 2 kits if you want to do both front and rear.
These shackles are an excellent way to get some extra tire clearance or accomodate lift spri
|
Our Price: $144.74 - $144.74 each
|
Original type temperature sending units screw into the intake manifold near the water jacket, and accept the stock female spade connector. Pipe thread measures 1/2"
|
Our Price: $52.63 each
|
This is the donut (metal and fiber ring gasket) for the exhaust pipe-exhaust manifold flange connection. This fits either the 3-bolt manifold or the 2-bolt manifold.
If you have a V8, you will need two. If you have a 4-cylinder, you will need only one.
If you have a heat riser valve, there is also
|
Our Price: $19.89 each
|
We only have three. New Old Stock.
This is the best side view mirror to use for your Scout II. New old stock mirror made by IH in the 1970's. This is the replacement mirror that your IH dealer would have sold you in 1970's.
- Mounting holes may need to be re-drilled -
|
Our Price: $742.99 EACH
|
Plastic heater valve replacement for all Scout 80 & 800, Scout II, Travelalls, and pickups with inline heater valve. While this is not a cadmium-plated steel unit like original, this plastic valve actually moves more easily, and will never rust away like the originals did. Install this and lubrica
|
Our Price: $56.73 each
|
New replacement cable. This cable comes in a 5'length and can be cut to fit. It is a 1/4" housing and the throw length(pulling on the knob)is up to 2" This cable will work as a replacement for a choke, hood release, throttle(pto applications), vent cable, or any other application you might need.
|
Our Price: $29.95 each
|
These are new replacement bulbs for Scout 800 instrument gauges.
|
Our Price: $1.26 each
|
Hub and rotor for Scout II with front disc brakes (2WD & 4WD) and for 1974-75 4x4 pickups and Travelalls.
These come complete with new hubs, new discs, new studs, and new bearing races.
|
Our Price: $224.26 each
|
All of the gas motors in all models of Scout and Scout II use these Champion brand spark plugs. We typically gap spark plugs to .035 when installing, which is very close to the Champion factory gap.
|
Our Price: $5.41 each
|
Due to its size, this product must ship by truck freight.
Four point roll cages for Scout II! 1.75" x 14 gauge tubing.
High quality 4-point cage is made from hot rolled electric welded steel tubing, and is designed to give you extra headroom over other cages.
It is also the ideal platform for mo
|
Our Price: $635.22 each
|
Kit includes:
2- green LEDs for turn signal indicator
1- red "brake failure"
1- amber/yellow "4x engage"
1- blue "high beam"
Chrome on steel body. These lights are not plastic and they will take a real beating.
Requires a 1/2" hole in dash. Made with LED's so they won't drain your battery.
|
Our Price: $32.92 each
|
Kit designed to allow a pre-1985 Chevy 350 motor to be mounted in a Scout II. These Universal engine mounts are designed for use on all types of 4WD and 2WD vehicles that have frame rail widths
up to 32". The bracket can be either welded or bolted into position. Kit includes hardware, mounts and bra
|
Our Price: $249.40 each
|
Emblem is for fender badges on all Scout IIs as well as the 1961 to 75 trucks & Travelalls. Dress up that truck with little detail items like this badge.
These are made of base metal and chrome-plated and enamel-painted. These are held on with metal posts on the back side.
SCOUT EMBLEM
IH fende
|
Our Price: $78.95 each
|
New Scout II ignition lock cylinder with keys
Comes with two unbranded keys that do not have the international logo
|
Our Price: $39.95 Each
|
New turn signal switch for your 1971-1976 IH Scout II.
(Looking for that hard-to-find 77-80 Turn Signal Swith? We've got it! See "related parts" below)
|
Our Price: $79.96 each
|
This seal kit fits Dana 27, Dana 30, and Dana 44 closed-knuckle front axles used in Scout 80, 800, pickups, and Travelalls. This kit seals around the large ball behind the knuckle.
This kit comes with the rubber seal, felt seal, metal seal retainers, and retainer bolts. One kit is enough to servi
|
Our Price: $83.17 each
|
This is a complete kit for your Scout 80 & 800 , it includes both battery cables and the engine ground strap. This kit will eliminate many electrical problems and make your Scout much more reliable. Intended for use with 4 cylinder engine.
|
Our Price: $102.87 each
|
FITS ORIGINAL SCOUT II GAS CAP
This fuel filler tube is a reproduction of the original. It is new, made of steel, and fits both Scout II gas and diesel, 19 and 33 gallon tank.
Will fit standard (SP12935) gas cap as well as our aftermarket locking gas caps (SP13749)
|
Our Price: $296.24 each
|
This is the perfect screw to use on all IH valve covers. This will fix a lot of your leaks.
|
Our Price: $12.56 for 6 Bolts
| |
