SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
These are new plastic fan shrouds for Scout II. These are designed for use with V8 engines, and they will fit 4-cylinder motors too. These may or may not work with the inline engines (258, SD-33). If you have one of those engines, call us anyway to make sure.
|
Our Price: $202.77 each
|
Overall width 2" inches. These spring bushing kits service one axle on your 800A or 800B. 800A and 800B spring bushings are 1.2" in diameter.
These bushings replace the ones located in the spring eyes as well as those located in the spring mounts welded to the frame.
|
Our Price: $70.85 each
|
Sold in milled steel bare, or Chome. These are brand new bumpers made by Scout Parts and are exact copies of the original factory bumper. This is not just a look-alike, it's exact!
|
Our Price: $483.97 each
|
These are new O-rings for the water pipes that run between the water pump housing and the cylinder heads on International V8 and 4-cylinder engines.
On 392IC motors (Improved Cooling) motors, the water pipes go to the front of the block, but the O-ring is the same.
There are 4 provided per s
|
Our Price: $8.87 each
|
This LED bulb replaces the side marker lamp in either the front or rear side marker of the Scout II, also works in the dash lamps.
|
Our Price: $11.88 each
|
Sold Each. New tail light lenses for your Scout II 1972 to March 1978 or D-series pickup 1969 to 1975.
This lens will work with your original chrome or plastic housing. After 1978 they went to a plastic bonded housing.
For complete kit or other parts See Item SP20843
|
Our Price: $39.12 EACH
|
Windshield wiper blade for your IH Scout 80 or Scout 800.
(Includes installation instructions)
NO RETURNS
|
Our Price: $19.48 each
|
Passenger side fuel tank filler neck (hose) for Scout 80 and Scout 800 fuels tanks on the passenger side of the vehicle. This assembly includes the air vent hose, and connects the fuel tank to the filler flange on the rear fender.
See also the Drivers side
|
Our Price: $133.45 each
|
All Scout II vehicles use this tail lamp housing gasket between the metal or plastic (depending on year) housing and the body. Without this gasket the tail lamp housing fills with water, the contacts corrode, and eventually the bulb fails.
1971-78 Scout II, 1969-75 IH Pickup
soft cork material
repl
|
Our Price: $14.75 each
|
This is a new Gasket for your fuel sender to gas tank.
|
Our Price: $8.20 each
|
This is a complete kit for your Scout 80 & 800 , it includes both battery cables and the engine ground strap. This kit will eliminate many electrical problems and make your Scout much more reliable. Intended for use with 4 cylinder engine.
|
Our Price: $102.87 each
|
THIS KIT IS FOR SCOUT II ONLY. If you have a good gauge and a good fuel tank sender but your gauge still does not work, this is the kit for you. This wiring harness bypasses your stock harness and provides the correct number of ohms to make your gauge read correctly. Scoutparts highly recommends
|
Our Price: $24.72 each
|
This is the donut (metal and fiber ring gasket) for the exhaust pipe-exhaust manifold flange connection. This fits either the 3-bolt manifold or the 2-bolt manifold.
If you have a V8, you will need two. If you have a 4-cylinder, you will need only one.
If you have a heat riser valve, there is also
|
Our Price: $19.89 each
|
We now have brand new shifter knobs to fit Scout 80, Scout 800, and pickups and Travelalls. This was used on 3 and some 4-speed transmissions used in C, K, KB, M, L, R, S, A, B, and C-series trucks.
Made of phenolic rubber like the original, This has a 3/8" SAE (fine) thread. If this is not c
|
Our Price: $31.53 each
|
If you have a 4 cylinder Scout 80, 800 there's a good chance you may need one of these. They tend to have gotten rusty and weak in the last 40 years.
|
Our Price: $23.87 each
|
Hose connects the plastic or metal fuel filler neck to the fuel tank, and is a direct replacement for the original hose.
This is a nice, industrial, heavy duty hose. (Be careful of the heavy metal wires embedded in the tubing.)
|
Our Price: $38.40 each
|
Kit includes one spring for each door lock mechanism.
|
Our Price: $25.30 IN STOCK NOW! EACH
|
CURRENTLY BACKORDERED
215114R1***You are ordering the pin pictured, if you want the slave cylinder order sp11773***
Fits Scout 80 and 800 with hydraulic clutches, extra heavy duty service. Clutch Slave Cylinder actuator pin. This part was made 3/16 longer than original equipment. Specifically manuf
|
Our Price: $53.13 BACKORDERED
|
This is a new knob for the hood release cable on the dashboard. This is the later version which was made of plastic, but can be used to replace the earlier metal knob too. Often these are completely missing, either because they split, or because the cable got stuck and the knob came off. If your
|
Our Price: $29.95 each
|
***seat belts currently made to order, lead time involved***
These 3 point seat belts have an adjustable buckle lead. They are much safer than the original 2 point seat belts.
They are NOT the type that the factory installed.
To use these seat belts you will have to fabricate a 3rd anchor point.
|
Our Price: $141.27 each
|
There are 14 screws and special washers here, which are enough screws to affix one Scout II door panel to the door.
|
Our Price: $22.34 each
|
We are making all new reproductions of this axle bumper. No one else makes these or has them. This one has the correct bolt, correct thread, correct dimensions. This part was used on most IH trucks built from 1957 to 1968 and on Scout 80s and 800s.
New reproduction axle suspension stop of OEM #
|
Our Price: $30.85 each
|
These are fabulous reproductions! 495512C2
Scout II, Scout Terra, Scout Traveler
|
Our Price: $128.17 each
|
We had a really hard time finding these, so we decided to make them ourselves. Replace your old filter with this and stop your oil filter adapter from leaking. If you are updating your older filter with a newer spin-on adapter, you will need one of these.
|
Our Price: $32.53 each
|
393250C2 - Most Scout II's with either 4 speed manual or automatic transmission use this transmission mount assembly. One side of the mount attaches to the transmission housing and the other side mounts to the cross member. This should also fit stock 1971-1974s with 3spd or 4spd manuals.
|
Our Price: $71.56 each
|
The later Scout II trucks used a plastic tail light housing. This is the replacement lamp socket for the upper socket which holds the tail and brake lamp (dual contact). Buy this socket if your old one is rusted and will not accept a tail lamp.
Made in the USA
 |
Our Price: $17.67 each
|
Tail light wiring harness (pigtail) for rear tail/brake bulb sockets.
|
Our Price: $34.95 each
| |
