SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
This clip replaces the original clip and spacer. It is made of a rigid plastic and will do the job as good as the original.
|
Our Price: $25.20 each
|
Gasket that goes on the top of your Scout 80, Scout 800 gas tank. Need one per gas tank. This gasket is only used on original metal fuel tanks.
|
Our Price: $11.42 each
|
This is the donut (metal and fiber ring gasket) for the exhaust pipe-exhaust manifold flange connection. This fits either the 3-bolt manifold or the 2-bolt manifold.
If you have a V8, you will need two. If you have a 4-cylinder, you will need only one.
If you have a heat riser valve, there is also
|
Our Price: $19.89 each
|
Holds your fuel tank in place. They are sold in pairs. The straps are 36" by 2" and come galvanized.
|
Our Price: $71.67 each
|
This travel top side window seal is a fantastic reproduction of the original. It fits great.
You'll notice that your original seal (or any you ever see on a travel top) has a seam in the center at the bottom of the window. This seal comes in a continuous loop but needs to be cut down slightly to 19
|
Our Price: $184.20 each
|
If you have a fancy fabric or vinyl interior door panel, These clips are probably what holds it on to the door. These were used on all IH scouts & trucks built in the 1960's. They almost always break when you remove the old corroded ones.
|
Our Price: $2.17 each
|
This is an NOS bolt for the connecting rods.
These are the bolts that attach your piston rods to the crankshaft.
|
Our Price: $29.20 each
|
Rear bearing, tapered. Fits Scout 80 with Dana 27 axles. Race is not included.
|
Our Price: $252.05 each
|
Now you can rebuild your own power steering gear with our rebuild kit! This comes with all of the seals, gaskets, and bearings required to rebuild your Saginaw power steering box at home.
Recirculating balls are not included, nor are they typically required.
We also can rebuild your old ste
|
Our Price: $149.25 each
|
Electric wiper motors are reliable, easy to install, and an excellent upgrade for any Scout 80 & 800. Kit includes hardware, harness, wiper arm, and blade for one side. Stainless housing.
Note : These fit really well for 1961-1965. Some modification to your dash will be required for the 66-71 Scou
|
Our Price: $158.10 IN STOCK NOW!
|
FITS ORIGINAL SCOUT II GAS CAP
This fuel filler tube is a reproduction of the original. It is new, made of steel, and fits both Scout II gas and diesel, 19 and 33 gallon tank.
Will fit standard (SP12935) gas cap as well as our aftermarket locking gas caps (SP13749)
|
Our Price: $296.24 each
|
We are making all new reproductions of this axle bumper. No one else makes these or has them. This one has the correct bolt, correct thread, correct dimensions. This part was used on most IH trucks built from 1957 to 1968 and on Scout 80s and 800s.
New reproduction axle suspension stop of OEM #
|
Our Price: $30.85 each
|
Kit includes one spring for each door lock mechanism.
|
Our Price: $25.30 IN STOCK NOW! EACH
|
Each kit of polyurethane bushings will service one axle and tighten up your ride quality while eliminating squeaks.
The overall length of these bushings is 2.25 inches, 1.25 outside diameter. this works with stock shackles or our aftermarket shackles.
|
Our Price: $97.98 each
|
This body mount kit is an extremely close reproduction of the original bushings used by International Harvester in the 1960s.
Every bump and curve has been reproduced in the smallest detail. These are not plastic washers repackaged to fool you into thinking that these are a body mount kit.
This
|
Our Price: $149.95
|
This clip has myriad uses on old vehicles of all makes. It holds the emergency brake cables at the pedal and in various holding brackets on the frame and in the rear wheel backing plates. It holds the brake hoses in their support brackets on the frame. It holds some of the steel brake lines again
|
Our Price: $3.39 EACH
|
Priced each. These brand new junior west coast style mirrors are great for Scouts, pickups, campers, and tow vehicles. The 10" X 5" mirror head is chrome with silvered glass, the tubing is heavy duty chrome finish with compression nuts. These have curved edges (more of a rounded rectangle) and are d
|
Our Price: $78.53 each
|
New replacement Clutch Master Cylinder for Scout 80/800
|
Our Price: $79.95 Each
|
This kit includes the two hoses that connect the defroster vents in your truck.
|
Our Price: $39.95 each
|
***Scout II top door seal special, proudly made in the USA*** Scout II door felt and squeegee for resealing the top of door opening of Scout II doors. These are the real deal, your windows won't rattle and will look original.
You will need 2 kits.
Outer 481437C1, 395872c1, 395873c1 - Inner 481437
|
Our Price: $72.37 each
|
These hose clamps are made of stainless steel, so they will never rust.
|
Our Price: $2.24 each
|
Rear Parking Brake Cable (Emergency Brake) This a rear parking brake cable for Scout II with a 100-inch wheelbase. Also called an e-brake.
1971-1978 Scout II brake cable
Made in the USA
393953c92 Scout II 1971-1978
|
Our Price: $149.95 each
|
After market non-oem Stainless Steel head light bezel rings. Excellent restoration piece. 9.25" OD 7.25" ID.
APPLICATION DETAILS:
1961-71 Scout-very close to original look
1941-49 K/KB- Fit all models with close to original look
|
Our Price: $39.95 EACH
|
Hose connects the plastic or metal fuel filler neck to the fuel tank, and is a direct replacement for the original hose.
This is a nice, industrial, heavy duty hose. (Be careful of the heavy metal wires embedded in the tubing.)
|
Our Price: $38.40 each
|
For #8 Screw.
|
Our Price: $1.44 each
|
Due to its size, this product must ship by truck freight.
Four point roll cages for Scout II! 1.75" x 14 gauge tubing.
High quality 4-point cage is made from hot rolled electric welded steel tubing, and is designed to give you extra headroom over other cages.
It is also the ideal platform for mo
|
Our Price: $635.22 each
|
This is a rebuild kit to fit the Holley Model 1904 as used by Scouts, Travelalls, and pickups. This includes the 152 and 196 4-cylinder motors and engines.
This same carb was used in IH trucks with the 220/240 Black Diamond and the 220/240 Silver Diamond engines.
|
Our Price: $143.76 each
| |
