SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
This fuel tank filler neck hose goes between the left side gas tank and the rear quarter panel on a Scout 80 or Scout 800. The flange seals to the outside of the body, and the assembly includes the vent hose as pictured.
We also have a Right side, passenger side available.
fuel tank filler neck l
|
Our Price: $133.45
|
We need to know if you have a 60s or 70s scout. Includes 2 bolts,4 washers,2 nuts. Each scout requires 4 bolts for the front seat and 3 bolts for the back seat.
|
Our Price: $5.83 each
|
This body mount kit is an extremely close reproduction of the original bushings used by International Harvester in the 1960s.
Every bump and curve has been reproduced in the smallest detail. These are not plastic washers repackaged to fool you into thinking that these are a body mount kit.
This
|
Our Price: $142.06 each
|
Scout 80/800 chrome air cleaner for 4 And 6 cylinder motors. Will also work on Scout II with 6 cylinder engines. Replaces the oil bath air cleaner with a paper air filter. Improves intake air flow, which allows motor to breathe easier. 6.5 inch diameter.
|
Our Price: $125.76 each
|
All Scout II vehicles use this tail lamp housing gasket between the metal or plastic (depending on year) housing and the body. Without this gasket the tail lamp housing fills with water, the contacts corrode, and eventually the bulb fails.
1971-78 Scout II, 1969-75 IH Pickup
soft cork material
repl
|
Our Price: $14.75 each
|
|
Our Price: $14.17 each
|
Windshield wiper blade for your IH Scout 80 or Scout 800.
(Includes installation instructions)
NO RETURNS
|
Our Price: $19.48 each
|
"O" ring, for water pipes on all IH engines .
|
Our Price: $2.97 each
|
Stainless steel bolt kit for your rear bumper. Holds your rear bumper on and will not rust and freeze up. A must for any restoration.
Made in the USA
|
Our Price: $10.58 each
|
Fits: 1971-80 Scout II, 1976-80 Traveler/Terra & 1969-75 Pickup/Travelall
Includes 4 metal bezels, 2 red lens/lights, 2 amber lens/lights, pre-installed foam gaskets and mounting hardware.
419799C1, 404498C21, 418977C91, 404155C91 amber, 404156C91 red
|
Our Price: $149.95
|
Gasket that goes on the top of your Scout 80, Scout 800 gas tank. Need one per gas tank. This gasket is only used on original metal fuel tanks.
|
Our Price: $11.42 each
|
This barrel clip fits a 1/8" stud and fits into a 11/64th hole, These are the little tiny guys that hold your emblems on in places were you do not have access to, like the back side of the sheet metal.
These were used on your tail gate of your scout to hold on the chrome "INTERNATIONAL".
, 28832
|
Our Price: $2.78 each
|
These hose clamps are made of stainless steel, so they will never rust.
|
Our Price: $2.24 each
|
This oil pan gasket fits the 4 and 8-cylinder motors used in International Harvester Scouts, trucks, Travelalls, and Metros.
IH oil gasket
151067R2
|
Our Price: $45.81 each
|
Each kit of polyurethane bushings will service one axle and tighten up your ride quality while eliminating squeaks.
The overall length of these bushings is 2.25 inches, 1.25 outside diameter. this works with stock shackles or our aftermarket shackles.
|
Our Price: $97.98 each
|
This is brand new vented fuel cap to fit all International trucks.
This also fits other trucks too, as well as tractors and industrial engine fuel tanks.
|
Our Price: $21.26 each
|
Rear bearing, tapered. Fits Scout 80 with Dana 27 axles. Race is not included.
|
Our Price: $252.05 each
|
Passenger side fuel tank filler neck (hose) for Scout 80 and Scout 800 fuels tanks on the passenger side of the vehicle. This assembly includes the air vent hose, and connects the fuel tank to the filler flange on the rear fender.
See also the Drivers side
|
Our Price: $133.45 each
|
Scout II ignition lock cylinder with key. This is a brand-new item.
Now comes with two gm branded keys that do not have the international logo as pictured
|
Our Price: $41.77 each
|
Dash bulbs for Scout II gauges.
|
Our Price: $2.13 each
|
If your Scout is like mine, most of the time it starts fine, and other times you try to start it and all you get is a click.
With the battery being new and the starter being new, it shouldn\'t happen. Turn the keys 5 or 6 more times and then it might start. The problem often is that your old ignitio
|
Our Price: $68.78 each
|
406683C1
This fuse panel Has been specifically designed to plug into your old original Scout II wiring without cutting & chopping on the original harness.
Remove the old glass tube panel and plug this into the old harness.
We can update any Scout harness that you order with a new updated blade ty
|
Our Price: $314.01 - $314.01 each
|
This is an NOS bolt for the connecting rods.
These are the bolts that attach your piston rods to the crankshaft.
|
Our Price: $29.2 each
|
This is the actuator for the turn signal switch on Scout II and D-series pickups and Travelalls, Metros, and some later Scout 800 vehicles. This was used in Saginaw steering columns. This is the part that bumps the swinging cam on the turn signal switch, and that causes the signal to shut off afte
|
Our Price: $27.08 each
|
Super good, super strong, super resistant to gas, oil and diesel. Use gloves when applying. So good that it is hard to get off your hands.
This item has to ship ground because it's ORM-D, which makes the freight high to remote locations.
|
Our Price: $15.61 each
|
The later Scout II trucks with the plastic tail light housings use this replaceable lamp socket. This is the lower of the two sockets, accepts a single contact reverse bulb, and is a direct replacement for you worn or rusted socket.
|
Our Price: $17.67 each
|
Brand new interior door handle for Scout 80 and Scout 800.
Exact reproduction of the original handle. Can also be drilled and used as a replacement for bolt on style handles used on some Scouts.
|
Our Price: $12.84
| |
