SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
Windshield top to frame seal, also known as the upper windshield seal, this has a 7 bolt pattern. It works for 1965-71 Scouts.
|
Our Price: $41.95
|
Kit includes one pair of motor mounts and hardware to mount a 4 cylinder motor in a Scout 1961-71.
|
Our Price: $178.87 each
|
These are new large "Scout II" decals.
|
Our Price: $30.95 each
|
Dash bulbs for Scout II gauges.
|
Our Price: $2.13 each
|
Emblems for 71-80 Scout II.
All emblems are sold separately, as well.
This kit includes:
2x New Scout II IH Fender Emblem
2x New Scout II Rear Side "II" Emblem
2x New Scout II Rear Side Emblem
|
Our Price: $389.64
|
For years we drove our Scouts without cup holders. One day we got tired of spilling coffee all over the seat and designed the floor mount cup holder.
The cup holder is made of heavy 18 gauge stainless steel (not at all flimsy), is laser cut, and is perfectly suited to mount in any Scout II without
|
Our Price: $49.95
|
***LIMITED QUANTITIES***SOLD EACH ******Very hard to find! New old stock trim moulding clips for Scout II.
YES, THERE ARE FOUR IN THE PHOTO. ALLOWING YOU TO SEE DIFFERENT ANGLES. YOU WILL ONLY RECEIVE ONE AT THIS PRICE. PRICED EACH.
|
Our Price: $38.93 EACH
|
Sold as a set of four. These are new replacement shackle Plates for Scout 80, 800. They do not come with bolts.
They are within 1/2" of stock height.3" center to center on the holes.
|
Our Price: $50.41 Set of 4
|
This body mount kit is an extremely close reproduction of the original bushings used by International Harvester in the 1960s.
Every bump and curve has been reproduced in the smallest detail. These are not plastic washers repackaged to fool you into thinking that these are a body mount kit.
This
|
Our Price: $142.06 each
|
Overall width 2" inches. 7/8" outside daimeter. Brand new spring bushings for your Scout 80 or Scout 800. One kit will service one axle and tighten up your ride quality while eliminating squeaks.
Flanged bushings are for 2 inch aftermarket shackles on an 80/800.
|
Our Price: $70.85 each
|
This is a plastic Sheet metal screw nut used in IH head lights, like head light bezels. Also can hold your head light bezel on to your grille.
Fits a #6 Screw and a 5/16" square hole
|
Our Price: $1.48 each
|
This is a new knob for the hood release cable on the dashboard. This is the later version which was made of plastic, but can be used to replace the earlier metal knob too. Often these are completely missing, either because they split, or because the cable got stuck and the knob came off. If your
|
Our Price: $29.95 each
|
Front Suspension Axle Stop Bumper Rubber
|
Our Price: $20.92 each
|
If you have a fancy fabric or vinyl interior door panel, These clips are probably what holds it on to the door. These were used on all IH scouts & trucks built in the 1960's. They almost always break when you remove the old corroded ones.
|
Our Price: $2.17 each
|
Easy to install - NO soldering MUST BE GROUNDED!
If your gauges are reading incorrectly or not at all, you may need this brand new high capacity solid state regulator kit. It replaces the old mechanical one behind your Oil/Temp gauge. NO MOVING PARTS! This regulator has a capacity far beyond the
|
Our Price: $60.17 each
|
This valve seat retains the valve spring. these are used on all IH 4 and 8 cylinder engines.
|
Our Price: $11.76 each
|
Rear Parking Brake Cable (Emergency Brake) This a rear parking brake cable for Scout II with a 100-inch wheelbase. Also called an e-brake.
Made in the USA
393953c92 1971-1978
|
Our Price: $184.02 each
|
Brand new windshield seal for all years of Scout II, Scout II Terra, and Scout II Traveller. This seal is a direct replacement for the worn or leaking seal you may currently have; replacing a bad seal will keep the windshield frame from rusting.
This comes with a black locking strip but accepts a c
|
Our Price: $150.4 each
|
Kit includes original type drain plug and drain plug washer for IH motors.
|
Our Price: $17.7 each
|
New Scout II Glove Box. Cardboard just like OEM, Looks great in your truck!
|
Our Price: $64.75 each
|
Passenger side fuel tank filler neck (hose) for Scout 80 and Scout 800 fuels tanks on the passenger side of the vehicle. This assembly includes the air vent hose, and connects the fuel tank to the filler flange on the rear fender.
See also the Drivers side
|
Our Price: $133.45 each
|
We now have brand new shifter knobs to fit Scout 80, Scout 800, and pickups and Travelalls. This was used on 3 and some 4-speed transmissions used in C, K, KB, M, L, R, S, A, B, and C-series trucks.
Made of phenolic rubber like the original, This has a 3/8" SAE (fine) thread. If this is not c
|
Our Price: $31.53 each
|
Price is for one front and one rear. If you have tinkered with the roll up windows of your scout 80 & 800 and you just can't make them roll up and down smoothly, there's a good chance you need new front
|
Our Price: $74.85 each
|
Emblem is for fender badges on all Scout IIs as well as the 1961 to 75 trucks & Travelalls. Dress up that truck with little detail items like this badge.
These are made of base metal and chrome-plated and enamel-painted. These are held on with metal posts on the back side.
|
Our Price: $78.95 each
|
Includes, housing, lens and LED lights and pigtail. This is an almost perfect fit. The screw holes are a match but the unseen recess may need to be trimmed 1/16"th with just a little bit of filing.
|
Our Price: $49.65 each
|
Kit includes:
2- green LEDs for turn signal indicator
1- red "brake failure"
1- amber/yellow "4x engage"
1- blue "high beam"
Chrome on steel body. These lights are not plastic and they will take a real beating.
Requires a 1/2" hole in dash. Made with LED's so they won't drain your battery.
|
Our Price: $32.92 each
|
Kit includes 2 high quality heavy duty shackles and hardware necessary to mount them on either the front or rear springs of any Scout 80 or Scout 800. Purchase 2 kits if you want to do both front and rear.
These shackles are an excellent way to get some extra tire clearance or accomodate lift spri
|
Our Price: $144.74 - $144.74 each
| |
