SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
Kit designed to allow a pre-1985 Chevy 350 motor to be mounted in a Scout II. These Universal engine mounts are designed for use on all types of 4WD and 2WD vehicles that have frame rail widths
up to 32". The bracket can be either welded or bolted into position. Kit includes hardware, mounts and bra
|
Our Price: $249.4 each
|
#21 in the above diagram is the part you are looking at
#24 is SP18769
#25 is SP10134
These are new side seals for use with the standard steel travel top used on Scout 80 & 800 trucks. These will work on the optional fastback sport top, but will not work on the optional half-cab top. These are mad
|
Our Price: $89.95 each
|
Fuel sender gasket o-ring for original steel fuel tanks. If you have an aftermarket polyethylene tank, you need SP19180.
|
Our Price: $7.08 each
|
Warn hub gaskets 2 are needed per side. there was a smaller gasket but it is very rare.
|
Our Price: $10.95 each
|
Scout II heavy-duty winter wiper blades are in stock and ready to ship. These blades work great with a small modification to the stock wiper arm to allow for the included screw and nylock nut to be used.
|
Our Price: $34.32 each
|
These are new large "Scout II" decals.
|
Our Price: $30.95 each
|
There are 14 screws and special washers here, which are enough screws to affix one Scout II door panel to the door.
|
Our Price: $22.34 each
|
Upper windshield frame seal that goes between frame to top
1972-80 Scout II, Terra, and Traveler
452085C2
|
Our Price: $87.54
|
Fits: 1971-77 Scout II & Terra/Traveler
Includes: 4 screws and 4 well nuts, enough to mount both of your rear arm rests
2 of each required per arm rest
|
Our Price: $14.95 Each
|
We now have brand new shifter knobs to fit Scout 80, Scout 800, and pickups and Travelalls. This was used on 3 and some 4-speed transmissions used in C, K, KB, M, L, R, S, A, B, and C-series trucks.
Made of phenolic rubber like the original, This has a 3/8" SAE (fine) thread. If this is not c
|
Our Price: $31.53 each
|
Finally available are original style transmission and transfer case mounts for your 3 speed Scout 80/800; keep your vehicle to spec while eliminating vibrations.
|
Our Price: $229.89 each
|
406683C1
This fuse panel Has been specifically designed to plug into your old original Scout II wiring without cutting & chopping on the original harness.
Remove the old glass tube panel and plug this into the old harness.
We can update any Scout harness that you order with a new updated blade ty
|
Our Price: $314.01 - $314.01 each
|
This clip replaces the original clip and spacer. It is made of a rigid plastic and will do the job as good as the original.
|
Our Price: $25.2 each
|
This is a factory-authorized reprint of the CTS-2304 service manual for all Scout II trucks built between 1972 and 1975 only. This is not anything like a Chilton's or a Haynes manual, but is a 600 page factory technical service manual with complete instructions and illustrations to guide you in you
|
Our Price: $129.01 each
|
For years we drove our Scouts without cup holders. One day we got tired of spilling coffee all over the seat and designed the floor mount cup holder.
The cup holder is made of heavy 18 gauge stainless steel (not at all flimsy), is laser cut, and is perfectly suited to mount in any Scout II without
|
Our Price: $49.95
|
Dash bulbs for Scout II gauges.
|
Our Price: $2.13 each
|
If your Scout is like mine, most of the time it starts fine, and other times you try to start it and all you get is a click.
With the battery being new and the starter being new, it shouldn\'t happen. Turn the keys 5 or 6 more times and then it might start. The problem often is that your old ignitio
|
Our Price: $68.78 each
|
Brand-New IH Scout II Accelerator / Throttle Cable Part. This cable is 28-5/8" end to end.
This is the REAL DEAL IH Part. part 440983C1
73-75 6-232/258 engines
To fit the 1973-1978 Scout II with 304 / 345 V8.
This cable has a socket fitting on the carburetor end, and a ball on the gas pedal en
|
Our Price: $104.5 each
|
This is the gasket between the side marker light housing and the body on 1971 to 1980 Scout II
|
Our Price: $4.53 each
|
These are the original factory spring bushings to fit all Scout 80 & Scout 800 springs. 7/8" diameter. These will give your truck the ride it had when it was new.
You may need a press to install these. Check out SP12758 for aftermarket urethane spring bushings that are easier to install.
|
Our Price: $18.82 each
|
So close to original that it\'s difficult to tell the difference. Many states do not require a front plate. Because of this, we have deleted the holes for the license plate.
Same original thickness and original mounting holes. Super close reproduction of factory original.
In stock now.
Fits bot
|
Our Price: $483.97 each
|
Restoration quality bumper stand-off brackets. Attention to detail makes a good restoration great! ****Priced per offset****.
Made in the USA
|
Our Price: $111.47 EACH
|
Now you can rebuild your own power steering gear with our rebuild kit! This comes with all of the seals, gaskets, and bearings required to rebuild your Saginaw power steering box at home.
Recirculating balls are not included, nor are they typically required.
We also can rebuild your old ste
|
Our Price: $154.25 each
|
We are making all new reproductions of this axle bumper. No one else makes these or has them. This one has the correct bolt, correct thread, correct dimensions. This part was used on most IH trucks built from 1957 to 1968 and on Scout 80s and 800s.
New reproduction axle suspension stop of OEM #
|
Our Price: $30.85 each
|
Brand New Scout 80/800 windshield seals! Soft and pliable to get you through the next 40 years.
|
Our Price: $146.67 each
|
Pertronix Ignitor kit for Holley gold box ignition V8 systems.
Kit REPLACES THE PICKUP IN THE DISTRIBUTOR AND ELIMINATES THE GOLD BOX FROM THE IGNITION SYSTEM!!!
This kit will eliminate your gold box problems, increase fuel economy, horsepower, and plug life. Easy to install kit has no moving part
|
Our Price: $168.95 - $210.95 each
| |
