SCOUTPARTS.COM stocks 1961-1980 International Harvester Scout 80, 800, 800A, 800B, Scout II, Terra and Traveler parts. We sell used Scout parts as well as common upgrades such as disc brake conversion kits, lift kits, fuel injection kits, offroad steering upgrades and roll bars. We're the best source for complete clutch kits, custom wiring harnesses, and gas tanks. We offer a full line of restoration and performance parts including Light Line original IH parts. We stock hard to find used, new and NOS (new old stock) parts. Both the Scout specialist and the new IHC enthusiast can count on us to find the Scout parts they need. As Scout owners, we drive Scouts and understand the needs of the 4x4 binder enthusiast and restoration customer alike. We have more parts listed on our site than anyone else on the internet and if we don't have it listed we can still probably get it. If you're looking for International Scout parts, you've found the right place.
Scoutparts.com gift certificates are the perfect gift for any
Scout enthusiast! Please call to order, we'll get one right
out to you. Can be used at Scoutparts.com, Travelallparts.com
|
|
All of the gas motors in all models of Scout and Scout II use these Champion brand spark plugs. We typically gap spark plugs to .035 when installing, which is very close to the Champion factory gap.
|
Our Price: $5.41 each
|
Properly maintained Dana 44 axles can last for hundreds of thousands of miles! Kit replaces Dana 44 rear axle bearings races and seals. One kit: axle bearing, outer axle seal, and inner axle seal for both sides of the axle.
|
Our Price: $217.75 each
|
Pertronix Ignitor kit for Holley gold box ignition V8 systems.
Kit REPLACES THE PICKUP IN THE DISTRIBUTOR AND ELIMINATES THE GOLD BOX FROM THE IGNITION SYSTEM!!!
This kit will eliminate your gold box problems, increase fuel economy, horsepower, and plug life. Easy to install kit has no moving part
|
Our Price: $168.95 - $210.95 each
|
If you have an A, B, or C-series Travelall or pickup, and cannot find blades for it, or yours have gotten so bad over the years that you cannot use it anymore, we have the correct replacement blades for you. These are new rubber blades and the bracket or holder that attaches it to the arm. The bla
|
Our Price: $42.81 each
|
***seat belts currently made to order, lead time involved***
These 3 point seat belts have an adjustable buckle lead. They are much safer than the original 2 point seat belts.
They are NOT the type that the factory installed.
To use these seat belts you will have to fabricate a 3rd anchor point.
|
Our Price: $141.27 each
|
This barrel clip fits a 1/8" stud and fits into a 11/64th hole, These are the little tiny guys that hold your emblems on in places were you do not have access to, like the back side of the sheet metal.
These were used on your tail gate of your scout to hold on the chrome "INTERNATIONAL".
, 28832
|
Our Price: $2.78 each
|
Front Suspension Axle Stop Bumper Rubber
|
Our Price: $20.92 each
|
NEW "Scout" script emblem. Give that restoration project the finishing touch with emblems like these.
860265R1
|
Our Price: $82.42 each
|
2 small and 2 large gaskets for both turn signal lens and bezels
Fits: 1950-55 L & R Series Pickup, 1950-55 Travelall
gaskets only, no lens
|
Our Price: $21.95
|
Radiator overflow bottle, in combination this a pressure cap, can keep your cooling system healthy for years to come.
Works great for your IH!
|
Our Price: $27.89 each
|
This seal is made for the lower rear cab top. The original was poorly designed because it allowed the metal of the top to rub against the metal of the bulkhead in direct contact, destroying your paint. This is new and improved!
|
Our Price: $59.95 each
|
A canister type Engine oil filter with a gasket for a Scout 80/800.
Scout engine oil filter
|
Our Price: $37.88 each
|
Easy to install - NO soldering MUST BE GROUNDED!
If your gauges are reading incorrectly or not at all, you may need this brand new high capacity solid state regulator kit. It replaces the old mechanical one behind your Oil/Temp gauge. NO MOVING PARTS! This regulator has a capacity far beyond the
|
Our Price: $60.17 each
|
This fits all IH motors, including 152, 196, 266, 304, 345, and 392. Make those persistent oil leaks disappear!
Gaskets may come in cork or rubber, depending on availability.
Not sold in pairs
If you have a V8, order two
|
Our Price: $16.95 Each
|
If you have a fancy fabric or vinyl interior door panel, These clips are probably what holds it on to the door. These were used on all IH scouts & trucks built in the 1960's. They almost always break when you remove the old corroded ones.
|
Our Price: $2.17 each
|
Original type temperature sending units screw into the intake manifold near the water jacket, and accept the stock female spade connector. Pipe thread measures 1/2" using ruler.
|
Our Price: $52.63 each
|
These are new U-joints to fit the front axle shafts on Dana-44 open-knuckle front axles used in Scout II, Travelalls, and pickups, including 1000, 1100, 1200, 1010, 1110, 1210, 100, 150, and 200 4x4 chassis.
|
Our Price: $46.68 each
|
Gasket that goes on the top of your Scout 80, Scout 800 gas tank. Need one per gas tank. This gasket is only used on original metal fuel tanks.
|
Our Price: $11.42 each
|
***PAINT CANNOT BE SHIPPED TO CALIFORNIA OR ABROAD***
This is the original International Harvester red color.
Must be ordered in case quantity. Ordering 1 = 6 aerosol cans.
|
Our Price: $80.08 each
|
Scout 80/800 from 1961-1971 use this pad for the clutch and brake pedal.
Scout 800, Scout 80
|
Our Price: $32.02 each
|
Rear axle outer oil seal scout 80 Dana 27.
|
Our Price: $29.38 each
|
***LIMITED QUANTITIES***SOLD EACH ******Very hard to find! New old stock trim moulding clips for Scout II.
YES, THERE ARE FOUR IN THE PHOTO. ALLOWING YOU TO SEE DIFFERENT ANGLES. YOU WILL ONLY RECEIVE ONE AT THIS PRICE. PRICED EACH.
|
Our Price: $38.93 EACH
|
Oil Pressure Sender For Scout II With Stainless Steel Dash Panel and New Gauge Combo Kit. If you have recently purchased our Stainless Steel Dash Panel and New Gauge combo kit "SP13689" you are going to want to replace your 30 year old oil sender with this new updated sender for the most accurate r
|
Our Price: $52.89 each
|
We have brand new gaskets to fit the front wheels hubs on Scout 80, Scout 800, Scout II, and the 1974 and 1975 pickups and Travelalls with 5-bolt wheels. This goes between the bearing hub and the locking hubs or hub drive flange, whichever the case may be.
|
Our Price: $6.6 each
|
Plastic heater valve replacement for all Scout 80 & 800, Scout II, Travelalls, and pickups with inline heater valve. While this is not a cadmium-plated steel unit like original, this plastic valve actually moves more easily, and will never rust away like the originals did. Install this and lubrica
|
Our Price: $56.73 each
|
All Scout II vehicles use this tail lamp housing gasket between the metal or plastic (depending on year) housing and the body. Without this gasket the tail lamp housing fills with water, the contacts corrode, and eventually the bulb fails.
1971-78 Scout II, 1969-75 IH Pickup
soft cork material
repl
|
Our Price: $14.75 each
|
This is a NEW Rubber bumper for your adjustable hood stop. You will be able to close your hood with out damaging your paint and it will also stop your hood from fluttering when you're driving over 30 miles per hour.
|
Our Price: $13.52 Each
| |
